ASE G1 Auto Maintenance and Light Repair practice test
Built for the ASE G1 Auto Maintenance and Light Repair certification test: engine service from oil changes, belts and cooling systems to filters, plugs and codes, automatic and manual transmission fluid and seal service, CV joints, drive shafts, axles and transfer cases, power steering, suspension, alignment, tires, wheels and TPMS, drum and disc brakes and power assist, battery, starting, charging and lighting, and basic A/C service, with Technician A and Technician B questions. Every question is original, with an explanation of why the right answer is right.
Try the free sample Buy the full set, $12 once
The free sample is 10 questions, graded, with no sign-up. Or get All-access for $9/month: every test on the site. An account keeps your progress on every device.
What the full set includes
- 110 original four-option questions, with an explanation for every answer
- 2 timed practice exams of 55 questions in 90 minutes, the full length of the real test
- Each exam weighted like the real one: 9 engine systems, 4 automatic transmission, 6 manual drive train and axles, 13 suspension and steering, 11 brakes, 8 electrical, 4 heating and A/C
- Study mode (instant feedback) and exam mode (timer, graded at the end)
- Drill by topic or only your weak spots; weak spots tracked across every attempt
- 15 extra drill questions on numbered drawings of a drum brake, a caliper, the hydraulic system and alignment geometry: name the part
Topics covered
- Engine systems
- Automatic transmission and transaxle
- Manual drive train and axles
- Suspension and steering
- Brakes
- Electrical
- Heating, ventilation and A/C
Sample questions
Question 1
A customer says the engine hesitates when accelerating. What should the technician do first?
- Replace the spark plugs, since they are a common cause
- Clear any stored codes and send the vehicle back out
- Ask when it happens, then road test to duplicate it
- Replace the fuel filter before making any other checks
Show the answer
C. Ask when it happens, then road test to duplicate it. The concern has to be verified and understood before any part is touched. Asking about the conditions and duplicating the hesitation shows where to start, while swapping parts first is guessing.
Question 2
A customer says the automatic transmission slips and a warning light is on. Before the road test, what should the technician do first?
- Retrieve and record any stored codes
- Clear the codes so only new ones show up
- Drain and refill the fluid before driving it
- Disconnect the battery to reset the control module
Show the answer
A. Retrieve and record any stored codes. Stored codes show what the control module has already seen and give the road test a direction. Clearing them throws that information away, and fluid service or a battery reset does not replace reading the codes.
Question 3
After a hydraulic clutch slave cylinder is replaced, the pedal feels soft and the transmission is hard to get into gear. What should the technician do?
- Bleed the clutch hydraulic system
- Replace the clutch disc and pressure plate
- Add gear oil to the transmission until it is full
- Shorten the pedal travel at the pedal stop
Show the answer
A. Bleed the clutch hydraulic system. Opening the hydraulic line lets air in, and air compresses instead of moving the release fork. Bleeding fixes it. A new disc or a pedal stop change does not cure a soft pedal after hydraulic work.
Not affiliated with or endorsed by the National Institute for Automotive Service Excellence (ASE). ASE is a trademark of its owner. The questions here are original practice material and are not the official test or the official ASE practice tests.