Cert Rehearsal

ASE A9 Light Vehicle Diesel Engines practice test

Built for the ASE A9 Light Vehicle Diesel Engines certification test: general diagnosis from smoke color and crankcase pressure to no-start and low power, cylinder heads, injector sleeves and valve trains, engine blocks, pistons and bearings, lubrication and cooling, turbochargers, VGT, glow plugs, EGR and the DOC, DPF, SCR and DEF aftertreatment, and fuel systems from lift pumps and water separators to high pressure common rail and HEUI injection and injector calibration codes, with Technician A and Technician B questions. Every question is original, with an explanation of why the right answer is right.

Try the free sample Buy the full set, $12 once

The free sample is 10 questions, graded, with no sign-up. Or get All-access for $9/month: every test on the site. An account keeps your progress on every device.

What the full set includes

Topics covered

Sample questions

Question 1

A customer says a diesel pickup loses power going up long grades but runs fine around town. What should the technician do first?

  1. Replace the fuel filters and road test to see if it helps
  2. Order a new turbocharger and install it before further testing
  3. Road test under similar load and watch scan tool data
  4. Clear all stored codes and ask the customer to bring it back
Show the answer

C. Road test under similar load and watch scan tool data. Verify the complaint by duplicating it and watching live data under load. Guessing at parts, or clearing codes before looking at them, throws away the evidence.

Question 2

A technician is about to install a cylinder head and finds engine oil standing in several of the head bolt holes in the block. What should be done before the bolts go in?

  1. Install the bolts and torque them, since the oil will act as a lubricant
  2. Install the bolts and torque to the low end of the range to avoid cracking
  3. Remove the fluid, clean the holes and chase the threads if needed
  4. Wipe the top of the holes with a rag and then install the bolts
Show the answer

C. Remove the fluid, clean the holes and chase the threads if needed. Oil or coolant left in a blind bolt hole can hydraulically lock the bolt, give a false torque reading and even crack the block. The holes must be cleaned out and the threads checked. Torquing to the low end of the range does not fix any of that.

Question 3

A diesel has a rear main seal that keeps leaking after replacement. A groove worn by the old seal lip can be felt on the crankshaft sealing surface. Which repair is best?

  1. Coat the new seal lip and the shaft with sealant
  2. Install a seal with a slightly larger outside diameter
  3. Install a thin wear sleeve over the sealing surface
  4. Polish the groove out with fine emery cloth
Show the answer

C. Install a thin wear sleeve over the sealing surface. A wear sleeve (wear ring) gives the new lip a fresh, smooth surface to ride on. Sealant and a bigger seal do not fix a groove under the lip, and sanding the shaft does not remove it.

Not affiliated with or endorsed by the National Institute for Automotive Service Excellence (ASE). ASE is a trademark of its owner. The questions here are original practice material and are not the official test or the official ASE practice tests.