ASE A8 Engine Performance practice test
Built for the ASE A8 Engine Performance certification test: general diagnosis from vacuum, compression and leak-down tests to cam timing, starting and charging, ignition systems from coils and plugs to crank and cam sensors, fuel delivery, port and direct injection, air induction, turbochargers and exhaust, the PCV, EGR, secondary air, catalytic converter and EVAP systems, and computerized engine controls from fuel trim and freeze frame to OBD II monitors, network faults and module programming, with Technician A and Technician B questions. Every question is original, with an explanation of why the right answer is right.
Try the free sample Buy the full set, $12 once
The free sample is 10 questions, graded, with no sign-up. Or get All-access for $9/month: every test on the site. An account keeps your progress on every device.
What the full set includes
- 100 original four-option questions, with an explanation for every answer
- 2 timed practice exams of 50 questions in 90 minutes, the length of the real scored test
- Each exam weighted like the real one: 12 general diagnosis, 8 ignition, 9 fuel, air induction and exhaust, 8 emissions control, 13 computerized engine controls
- 16 extra drill questions on numbered drawings of a turbocharger system, an ignition scope pattern and a crankshaft sensor signal: name the part
- Study mode (instant feedback) and exam mode (timer, graded at the end)
- Drill by topic or only your weak spots; weak spots tracked across every attempt
Topics covered
- General diagnosis
- Ignition system diagnosis and repair
- Fuel, air induction and exhaust systems
- Emissions control systems
- Computerized engine controls diagnosis and repair
Sample questions
Question 1
A customer says the engine stumbles once in a while on cold mornings, but it ran fine when the shop drove it. What should the technician do first?
- Replace the plugs and wires to cover the usual causes
- Clear the stored codes and send the vehicle back out
- Ask when it stumbles and try to duplicate that
- Install a new coolant temperature sensor and retest
Show the answer
C. Ask when it stumbles and try to duplicate that. The concern has to be verified under the conditions the customer describes before any part is touched. Replacing parts or clearing codes on a problem nobody has seen is guessing.
Question 2
A customer says the engine misfires only during hard acceleration and runs smooth at idle and light cruise. Which of these is the most likely cause?
- A restricted PCV hose at the intake manifold
- A dirty cabin air filter behind the glove box
- Worn plugs with an excessive electrode gap
- A low coolant level in the overflow reservoir
Show the answer
C. Worn plugs with an excessive electrode gap. Cylinder pressure rises under load, so the coil has to supply more voltage to jump the gap. A wide gap pushes the demand past what the coil can deliver and the cylinder misfires. A PCV hose or a cabin filter does not cause a load-only misfire.
Question 3
A fuel injected engine cranks a long time before it starts on a hot restart, then runs fine. A gauge on the rail shows pressure falling to near zero within a minute of key off. Which of these is the most likely cause?
- A fuel filter that is partly restricted
- A leaking pump check valve or injector
- A pump relay with burned contacts
- A tank vent line that is plugged
Show the answer
B. A leaking pump check valve or injector. Pressure that bleeds off quickly after shutdown means fuel is leaking back through the pump check valve or past an injector or regulator. The engine then needs a long crank to rebuild pressure. A restricted filter or relay problem would show up while running, not as a bleed-down.
Not affiliated with or endorsed by the National Institute for Automotive Service Excellence (ASE). ASE is a trademark of its owner. The questions here are original practice material and are not the official test or the official ASE practice tests.