Cert Rehearsal

ASE A3 Manual Drive Train and Axles practice test

Built for the ASE A3 Manual Drive Train and Axles certification test: clutch diagnosis from pedal feel to flywheel runout, manual transmissions and transaxles from shift linkage to synchronizers, shaft endplay and the transaxle's differential, drive shafts, U-joint working angles and CV joints, rear axles from pinion depth and backlash to limited slip and axle bearings, and four-wheel and all-wheel drive from transfer cases to hubs and couplings, with Technician A and Technician B questions. Every question is original, with an explanation of why the right answer is right.

Try the free sample Buy the full set, $12 once

The free sample is 10 questions, graded, with no sign-up. Or get All-access for $9/month: every test on the site. An account keeps your progress on every device.

What the full set includes

Topics covered

Sample questions

Question 1

A car with a cable-operated clutch slips under hard acceleration. At the pedal there is no free play, and the cable has no slack. Which is the most likely cause?

  1. The cable is too tight, so the bearing rides on the fingers
  2. The input shaft bearing is worn and is dragging on the input shaft
  3. The pedal return spring is weak and the pedal rises too slowly
  4. The cable has stretched, which leaves far too much free play now
Show the answer

A. The cable is too tight, so the bearing rides on the fingers. With no free play the release bearing stays against the diaphragm fingers and relieves some clamp load, so the disc slips under torque. Too much free play would cause incomplete release, not slipping.

Question 2

A transmission clashes going into second gear on upshifts. Every other gear shifts smoothly with the clutch fully released. Which of these is the most likely cause?

  1. Too much clutch pedal free play
  2. A worn second gear blocking ring
  3. A weak detent spring on the 1-2 rail
  4. A worn input shaft front bearing
Show the answer

B. A worn second gear blocking ring. Clash in one gear only points at that gear's synchronizer. A clutch that does not release would clash in every gear, and a weak detent spring causes jumping out of gear, not clash.

Question 3

A front wheel drive car makes a groaning noise from the transaxle area only during tight turns and is quiet when driving straight. The axle shafts and CV boots check good. Which of these is the most likely cause?

  1. Worn input shaft bearing
  2. Worn differential spider gears
  3. Worn release bearing
  4. Worn reverse idler gear bushing
Show the answer

B. Worn differential spider gears. Pinion and side gears only rotate against each other when the wheels turn at different speeds, as in a turn, so wear there shows up in turns. An input shaft or release bearing noise would not depend on turning.

Not affiliated with or endorsed by the National Institute for Automotive Service Excellence (ASE). ASE is a trademark of its owner. The questions here are original practice material and are not the official test or the official ASE practice tests.