Cert Rehearsal

ASE A2 Automatic Transmission/Transaxle practice test

Built for the ASE A2 Automatic Transmission/Transaxle certification test: diagnosis by road test, pressure test, scan tool and meter across conventional automatics, CVTs and dual-clutch units, torque converters and lock-up, electronic pressure control and shift quality, in-vehicle service from linkage and range sensors to valve bodies, servos and fluid checks without a dipstick, and the unit out of the car from converter installation to clutch pack clearance, with Technician A and Technician B questions. Every question is original, with an explanation of why the right answer is right.

Try the free sample Buy the full set, $12 once

The free sample is 10 questions, graded, with no sign-up. Or get All-access for $9/month: every test on the site. An account keeps your progress on every device.

What the full set includes

Topics covered

Sample questions

Question 1

A front-drive car has a six-speed transaxle with no torque converter. Scan data shows two input shaft speed sensors, and the gears are split into an odd set and an even set. What type of transaxle is this?

  1. A conventional planetary automatic with a lock-up clutch
  2. A belt-type continuously variable transaxle
  3. A dual-clutch automatic transaxle
  4. A manual transaxle with an electric shift motor
Show the answer

C. A dual-clutch automatic transaxle. Two input shafts with odd and even gear sets, each fed by its own clutch, and no converter describe a dual-clutch design. A CVT has no fixed gears, and a planetary automatic uses a converter.

Question 2

After a shift cable is replaced on a column shifted vehicle, the indicator shows Park while the transmission is actually in Neutral, and the engine also cranks in Reverse. Which of these is the most likely cause?

  1. A worn parking pawl inside the transmission case
  2. The cable is not adjusted to the manual lever
  3. A failed relay in the starter control circuit
  4. Low fluid level letting the manual valve float
Show the answer

B. The cable is not adjusted to the manual lever. The indicator, the starter lockout and the manual valve all depend on the selector and the transmission lever agreeing. A cable that was not adjusted to the manual lever detent after replacement puts them out of step. A parking pawl or fluid level would not change what the indicator and starter circuit report.

Question 3

With the transaxle out of a vehicle, the technician finds engine oil wetting the back of the engine and the flex plate, coming from behind the crankshaft flange. What should be done before the transaxle goes back in?

  1. Replace the leaking rear crankshaft seal while it is exposed
  2. Install the transaxle and seal the bellhousing joint with RTV
  3. Replace the transaxle front pump seal and install the unit
  4. Wipe the area clean and recheck for a leak after a road test
Show the answer

A. Replace the leaking rear crankshaft seal while it is exposed. The oil is coming from the engine rear main seal, and it is far easier to replace with the transaxle out. Sealer at the bellhousing hides the leak and the oil will keep fouling the converter area, and the pump seal is a different leak path.

Not affiliated with or endorsed by the National Institute for Automotive Service Excellence (ASE). ASE is a trademark of its owner. The questions here are original practice material and are not the official test or the official ASE practice tests.