Cert Rehearsal

ASE A1 Engine Repair practice test

Built for the ASE A1 Engine Repair certification test: general engine diagnosis with vacuum, compression, leak-down and power balance tests, cylinder head and valve train, engine block, lubrication and cooling, and the fuel, electrical, ignition, air induction and exhaust faults that show up as engine problems, with Technician A and Technician B questions. Every question is original, with an explanation of why the right answer is right.

Try the free sample Buy the full set, $12 once

The free sample is 10 questions, graded, with no sign-up. Or get All-access for $9/month: every test on the site. An account keeps your progress on every device.

What the full set includes

Topics covered

Sample questions

Question 1

A customer says the engine knocks on a cold start, but the noise is gone by the time the vehicle is in the bay. What should the technician do first?

  1. Pull the oil pan and inspect the rod bearings for any wear or damage
  2. Replace the hydraulic lifters based on the customer's description
  3. Let the engine cool down and verify the noise on a cold start
  4. Return the vehicle with no repair because the noise is gone now
Show the answer

C. Let the engine cool down and verify the noise on a cold start. The concern has to be verified under the conditions the customer described, and this one only shows up cold. Tearing into the engine or replacing parts before hearing the noise is guessing.

Question 2

A cylinder head from an engine that overheated measures beyond the manufacturer's warpage limit when checked with a straightedge and feeler gauge. What should the technician do?

  1. Install a thicker head gasket to make up for the low area
  2. Tighten the head bolts past the specified torque to pull it flat
  3. Machine it if it stays within minimum thickness, or replace it
  4. Coat both sides of the gasket with sealer to fill the low spots
Show the answer

C. Machine it if it stays within minimum thickness, or replace it. Warpage past the limit has to be removed by machining the head flat, and only if enough metal remains to stay above the minimum thickness; otherwise the head is replaced. A thicker gasket, extra torque or sealer will not make a warped head seal and can crack the head or blow the gasket.

Question 3

A dial bore gauge is used on a cylinder. The diameter reads the same at the top, middle and bottom of the ring travel, but at any one level the reading across the crankshaft differs from the reading in line with it. Which condition does this describe?

  1. Cylinder wall taper
  2. Cylinder wall glazing
  3. Out-of-round
  4. A ring ridge at the top
Show the answer

C. Out-of-round. Out-of-round is a difference between two readings taken at the same level, 90 degrees apart. Taper is a difference between readings at different levels, and glazing is a surface condition the gauge does not measure.

Not affiliated with or endorsed by the National Institute for Automotive Service Excellence (ASE). ASE is a trademark of its owner. The questions here are original practice material and are not the official test or the official ASE practice tests.